A-A-52412A
3.17 Marking. All markings shall be durable and permanent to withstand usage encountered in
service and shall include the following information, as a minimum:
a. Manufacturer s CAGE code.
b. Operation markings.
Type I
- see figure 1
Type II
- see figure 2
c. Part identification
3.18 Workmanship. The inclinometer shall be free of defects such as burrs, chips, sharp edges,
cracks, unblended radii, surface defects, dirt, grease, corrosion products, or other foreign matter
that would affect appearance and performance. All required marking shall be neat, sharply
defined, and permanent.
4. REGULATORY REQUIREMENTS. The offeror/contractor is encouraged to use recovered
materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal
Acquisition Regulation (FAR).
5. PRODUCT CONFORMANCE PROVISIONS
5.1 Product conformance. The products provided shall meet the salient characteristics of this
Commercial Item Description, conform to the producer s own drawings, specifications,
standards, and quality assurance practices, and be the same product offered for sale in the
commercial marketplace. The government reserves the right to require proof of such
conformance.
6. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or
order (see 7.2).
7. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is
not mandatory.)
7.1 Addresses for obtaining copies of referenced documents.
7.1.1 Non-Government publications. IEEE/ASTM SI10, "Use of the International System of
ASTM International, P.O. Box C700, West Conshohocken, PA 19428-2959.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business